RPM Feed from Radical SR4 Kawasaki Carbs

JM Racing
Posts: 1
Joined: Thu Mar 25, 2010 8:31 pm

RPM Feed from Radical SR4 Kawasaki Carbs

Postby JM Racing » Fri Mar 26, 2010 2:36 pm

Hi,

I believe I can take the RPM feed from the coil +ve side and run it into the low level input on the DL 1 ?

I am a novice at this sort of thing so does this sound correct ? I am guessing the other input on the DL1 would then need to be to an earth ?

Any pointers greatfully received.

Thanks

Support

Postby Support » Tue Mar 30, 2010 11:06 am

When taking an RPM signal from the ignition system you need to take a feed from the negative side of the coil and connect that to the High Level RPM input or "rh" on the back of the DL1, this needs to be well grounded to produce a good rpm feed.

Please see this page of the Knowledge Base for further information:
http://www.race-technology.com/wiki/ind ... sionPickup


Return to “Installation questions”

Who is online

Users browsing this forum: No registered users and 21 guests