So I thought I would share exactly how to do this as I found this hard to figure out with the limited data posted here and on the AEM forum. Hopefully this will help the next guy trying to get these two products to talk.
- Connect your straight through Serial cable to your AEM EMS as though you are going to program your ECU
- Launch AEM Pro
- Connect to ECU
- Once connected to the ECU, Click Setup -> Advanced -> Telemetry ->Telemetry Setup
- Change the Parameter Count to 19
- Change the Header byte to 0x55
- Verify the Enabled check box is checked.
- Set the Baud rate to 19200
- Verify that Parity is set to None
- Add the following parameters in the following order:
- Engine Speed
- Engine Load
- Throttle
- Air Temp
- Coolant Temp
- ADRC11
- ADRC13
- ADRC14
- ADRC17
- ADRC18
- ADRC15
- ADRC16
- ADRC108
- O2 #1
- O2 #2
- Vehicle Speed
- Gear Calculated
- Error #1
- Error #2
- Click Show Info
- Verify that the setting match the values above
- Click OK
- Click OK