New style CAN adapter wiring

Peter Carroll/Toronto
Posts: 110
Joined: Wed Jul 04, 2007 11:33 pm
Location: Toronto, Canada
Contact:

New style CAN adapter wiring

Postby Peter Carroll/Toronto » Fri Jun 11, 2010 2:44 am

Is it possible to power the previous Serial CAN adapter off the serial connector as with the newest CAN adapter? Of course you would need to also add the power wires to the terminator for reflashing/programming.

I'm looking to simplify as I rewire things.
Peter Carroll, Toronto, Canada
DL1 and Dash2 - http://DriversMeeting.com/pcarroll

Support

Postby Support » Fri Jun 11, 2010 12:23 pm

Yes, you need to connect the power wires for the adapter through to pin 7 for +12v and to pin 5 for gnd on the d-type connector. There will be enough cores in the wires to do this without using the figure 8 power cable, but you might have to cut the ends of the connectors and start again to have enough spare wire to do this.


Return to “Installation questions”

Who is online

Users browsing this forum: No registered users and 29 guests