Dash3 configuration updating - not always possible
Posted: Fri Jul 30, 2010 9:21 am
Hello,
I'm using a Dash3, DL1 and Video4 equipment.
From time to time I want to change screens on my Dash 3 but it often refuses to accept the DASH.HEX file.
I stuck the CF card into the video4 slot, then after about 10 seconds the Dash screen shut its background light off and in most cases a "Race Technology" screen appears.
Then after a few minutes the light on the screen is switched on again but there are no changes to the config and the DASH.HEX hasn't been moved to the "Done" folder.
What can I do to make the updating more consistent?
Cheers
Chris
I'm using a Dash3, DL1 and Video4 equipment.
From time to time I want to change screens on my Dash 3 but it often refuses to accept the DASH.HEX file.
I stuck the CF card into the video4 slot, then after about 10 seconds the Dash screen shut its background light off and in most cases a "Race Technology" screen appears.
Then after a few minutes the light on the screen is switched on again but there are no changes to the config and the DASH.HEX hasn't been moved to the "Done" folder.
What can I do to make the updating more consistent?
Cheers
Chris