Page 1 of 1
CAN interface - S80Pro/Dash2/DL1
Posted: Wed Sep 08, 2010 12:46 pm
by pacosnik
I have a question about installing S80Pro, Dash2 DL1 and to work together. I want to use the CAN interface. Can I use standard CAN interface or having to buy this ECU interface - CAN (DTA S80)?
Regards,
Plamen Angelov
Posted: Mon Sep 13, 2010 8:42 am
by Support
Morning,
From our records the S80 has the same output format as the S60 - and we have a CAn configration file for this that is already in use with lots of customers.
You can order a standard CAN interface and load on this configuration, or if you tell us what the CAN adapter is for when you order it - we can pre-configure it for you.
Kind regards,
support
Re: CAN interface - S80Pro/Dash2/DL1
Posted: Sat Jan 20, 2018 4:51 pm
by KoenDelvaux
Hello "support",
At first, in 2014, I ordered an DL1club with dash4pro (I believe it was fairly new in OLED) and an KMS-interface cable.
Because I didn't install the KMS directly, after some time I also ordered an OBD-interface cable.
I ran my Z3-race car for some time with this OBD-interface cable + some direct analogue inputs.
Now I have installed a DTA S100pro, instead of the KMS (as KMS is not able to operate the BMW's vanos system).
Can I reuse the KMS-cable?
Thanks,
Koen Delvaux
Re: CAN interface - S80Pro/Dash2/DL1
Posted: Tue Jan 23, 2018 9:07 am
by racetec
Hello
The interface will need to be returned to Race Technology to be reconfigured to use with the DTA.
Please contact service at race - technology dot com for further details and cost information if you would like to proceed with this.