I have set the RPM feed from my ECU (Megajolt), by piggy backing the tacho feed (to a Stack ST200). The Tacho works correctly. I have the Tacho feed going to the rL input. The rG is to a ground on the chassis.
The Megajolt documentation states that the " TACH OUT signal provides a 12V pulse for every ignition event".
Data is being logged, however the data does not tally with usage. I have tried changing a number of settings in Analysis (min, max, sensor type) to try to understand the data. All of which do not make the data match expectations.
Questions:
1. What can I change to make the data understandable in Analysis?
2. Should I have connected the tacho input to the rH?
Skip.
RPM Input DL1
Return to “Installation questions”
Who is online
Users browsing this forum: No registered users and 114 guests