Hi, I am using the tach signal from my old dash (dial guage instruments) for my Dash 2 and it is giving a higher reading than the ECU. My Apexi ECU has a hand controller with digital readout and at 1350 RPM my Dash 2 is showing 2000 RPM approximately. Is there a conversion to tell me how many pulses per rev that I need to configure the RPM too?
My old dash and the ECU hand controller did have the same readings.
Thanks in advance for any help.
RPM scaling for configuring Dash 2
RPM scaling for configuring Dash 2
IF IT AIN'T GOT TURNS IT AIN'T RACING
Return to “Installation questions”
Who is online
Users browsing this forum: No registered users and 10 guests