Dash2 loses data signal from ECU
Posted: Fri Jun 13, 2014 5:17 pm
I have a Dash2 display connected to a Syvecs ECU. The Dash2 receives all it's info from the ECU via a CAN interface module.
Whilst in use the display seems to lose its connection briefly so gives incorrect readouts of various parameters. I have also noticed the serial symbol is randomly going on/off.
I haven't yet checked all the connections but will be over the weekend, everything is soldered so can't see this being an issue.
Just curious if anybody has had a similar issues and what the cause was.
Thanks
Steve
Whilst in use the display seems to lose its connection briefly so gives incorrect readouts of various parameters. I have also noticed the serial symbol is randomly going on/off.
I haven't yet checked all the connections but will be over the weekend, everything is soldered so can't see this being an issue.
Just curious if anybody has had a similar issues and what the cause was.
Thanks
Steve