DL1 - Video4 - Dash 2 - 355 Challenge

Tristec
Posts: 11
Joined: Fri Jun 17, 2011 8:46 pm

DL1 - Video4 - Dash 2 - 355 Challenge

Postby Tristec » Mon Jul 14, 2014 8:30 am

Hi,

My 355 has a working DL1 -> Dash 2 installed, and I have the configuration files.

Dash
https://dl.dropboxusercontent.com/u/9599895/355%20setup/V1-DL1-DASH/Dash.dat

DL1
https://dl.dropboxusercontent.com/u/9599895/355%20setup/V1-DL1-DASH/SETUP.BIN

Interestingly, when comparing the recommended setup and the actual setup I noted that the GPS and RPM was set on the DL1 to transmit at 5Hz, not 25Hz


I have added a Video4 and a Y-Cable to feed the DL1 data to the Video4 and then into the Dash.

Updated DL1
https://dl.dropboxusercontent.com/u/9599895/355%20setup/V2-DL1-VID4-DASH/SETUP.BIN


Updated Video4
https://dl.dropboxusercontent.com/u/9599895/355%20setup/V2-DL1-VID4-DASH/DEFAULT.VGL

Dash has not been changed.

I now have all the data successfully displayed on the Video4 (but using the Video4 internal GPS).

However, on the Dash I get all sensor data as before (e.g. water temp, oil pressure), however no Revs or GPS data. I also don’t get any sector/lap times sent to the dash although they are recorded in the Video4.


Any Ideas?

The difference I have between the specified Video4 config in the manual is I’ve reduced the output frequency for revs and GPS to 5Hz as that is how the DL1 was set when purely with the DASH2, so thought I’d see if that would help. It didn’t.

Note they didn’t work with 25Hz either, so that may not be the error.

Cheers,
Tris

Tristec
Posts: 11
Joined: Fri Jun 17, 2011 8:46 pm

Postby Tristec » Wed Jul 16, 2014 10:19 am

Any clue? I'm off to Spa this weekend and would like a dash if possible. Will have a play on Friday when testing but any clues?

Maybe disable the GPS/Accel from the DL1, so only one set traveling through the IO?


Return to “Installation questions”

Who is online

Users browsing this forum: No registered users and 34 guests