- * ViPEC is setup as detailed on http://www.race-technology.com/wiki/ind ... NInterface
* I've used an oscilloscope to verify that there is data on the CAN H & CAN L lines from the ECU
* CAN H & CAN L are connected to the correct pins and the 120Ohm resistor is present
* If the CAN adapter is connected to the ECU and then connected to the live monitor software I can see the beacon data being transmitted but no CAN data
* When the CAN adapter is connected to the DASH4PRO the dash reports serial errors and no other data
Both the CAN Adapter and DASH4PRO were supplied direct from Race Technology.
I'm at a bit of a loss on what to try next, there is no way of verifying the setup in the CAN adapter so all I can do is try reprogramming it based on the ViPEC setup I was sent by technical support. Any advice on things I can try/check to isolate the problem are most welcome.