Dash 2 pro connection with AIM vems
Posted: Mon Oct 23, 2017 8:54 pm
I am trying to connect my VEMS ecu to my Racetech Dash2 pro and am having problems. Both are less than about 2 years old and VEMS is running quite recent firmware. I ordered the Dash 2 with built in ECU comms for VEMS AIM protocol and so i hoped things would be easy. I cant get anything on my DASH 2 from VEMS. So i have been trying to make sure i am getting something from the VEMS ecu on a PC terminal program. When connected to the normal RS232 port i get constant "rubbish" from vems which may be the aim protocol or just rubbish. It just looks like constantly updating data that makes no sense to me. AIM is enabled in Vems tune. Can anyone confirm the following:
What should AIM protocol look like when viewed on a terminal screen?
I am connected to the "normal" RS232 port on vems
Should i use a normal cable or a NUL cable?
Is there any special software I can run on the dash 2 to read the raw data it is recieving?
Thanks des.
What should AIM protocol look like when viewed on a terminal screen?
I am connected to the "normal" RS232 port on vems
Should i use a normal cable or a NUL cable?
Is there any special software I can run on the dash 2 to read the raw data it is recieving?
Thanks des.