Page 1 of 1

Dash 2 configuration

Posted: Wed May 09, 2018 6:46 pm
by lotus7
Long time DL1 M2 user, now awaiting delivery of my Dash2

Can I configure the Dash2 , using the Legend software on the laptop , without it being connected to the Dash via the RS232 then save the config file on the laptop.
Then later, when the dash is installed , import the config file and send it via the RS232 to the Dash ?
I've run through config'ing all my DL1 analog variables that I want displayed , creating the equations , then saved the file
When importing the file later towork on it, all data is lost.
How is this done , or must I be connected ?

Re: Dash 2 configuration

Posted: Fri May 11, 2018 6:54 am
by racetec
Sorry I don't totally understand the question. You can set up a DASH2 configuration on your PC and save it on your PC. You can then reload it and send it over to the DASH2 via the RS232 connection to the DASH2. You can also read back the configuration from the DASH2 with the new V10 firmware.

Martin