I bought a used DL1 Club with a Dash4 Pro and a "CAN adapter" with an OBD connector. My car is a '00 Boxster which does not have CAN. Now, I can't figure out if the non-CAN interface of my car's OBD connector is at all supported by RT hardware - is it? If so, what hardware would that be and can I somehow figure out which adapter I've got? I've seen some references to LEDs and I can't find any.
I tried reflashing it with the "Enable OBD mode" checkbox enabled but I don't seem to receive any data, not using the Live Monitor nor when it is connected to the DL1.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests