Using the new style DL1 rear connector
Posted: Fri May 04, 2007 5:10 pm
The newest DL1s have a single rear connector with a double row of connections. It has spring loaded wire retention unlike the previous screw retained connector.
It's not very obvious, though, how to insert and remove the wires, and our literature is not yet updated.
I'll try to get a picture posted next week, but 'til then a verbal description-
The round holes are the wire terminal connections. Each round hole has a matching square hole. To insert or remove a wire, simply insert a small screwdriver tip into the square hole, displacing the internal spring.
Simple once you've done it twice!
It's not very obvious, though, how to insert and remove the wires, and our literature is not yet updated.
I'll try to get a picture posted next week, but 'til then a verbal description-
The round holes are the wire terminal connections. Each round hole has a matching square hole. To insert or remove a wire, simply insert a small screwdriver tip into the square hole, displacing the internal spring.
Simple once you've done it twice!