Bocsh Sensor Wiring
Posted: Wed Apr 02, 2008 6:35 pm
Hello,
Please can you give me some advice to give me some more confidence before I blow things up.
ok I’m just about to start connecting my DL1 and Dash2, but before I get the soldering iron out, I just want to check I’m doing everything correct.
I’m thinking of making the below circuit
(Each resistor would be 1k.)
Can you see any problems in this?
Also would I be able to log values from the DA channels in the DL1?
If I am sharing a sensor with my ECU (TPS & MAP) I assume I simply ‘T’ in to the variable voltage side of the sensor, and connect to one of the inputs? I assume I don’t need to use a 1k resistor with these too?
any advice / comments would be great,
Cheers
Jim
Please can you give me some advice to give me some more confidence before I blow things up.
ok I’m just about to start connecting my DL1 and Dash2, but before I get the soldering iron out, I just want to check I’m doing everything correct.
I’m thinking of making the below circuit
(Each resistor would be 1k.)
Can you see any problems in this?
Also would I be able to log values from the DA channels in the DL1?
If I am sharing a sensor with my ECU (TPS & MAP) I assume I simply ‘T’ in to the variable voltage side of the sensor, and connect to one of the inputs? I assume I don’t need to use a 1k resistor with these too?
any advice / comments would be great,
Cheers
Jim