TPS % Problem
Posted: Sat May 17, 2008 12:46 am
by nikpro
When my throttle is fully closed the voltage from the TPS sensor is 0.82v. I have entered this value in the formula table to read 0% but when I graph the TPS% fully closed shows approx 5% - Why? I have checked the voltage and it is .82v
Posted: Sat May 17, 2008 4:41 pm
by tristancliffe
Did you put in other values into the equation generator, like full throttle as well? What happens if you remove the equation, and just show voltage? And what does the value equal if you put the voltage through the equation manually (on paper, or a calculator)?