Help! No RPM, Oil P or Oil Temp readings
Posted: Fri Aug 22, 2008 9:54 pm
Any help asap would appreciated, entered at Brands on sunday!
Just Installed a Mk1 DL1 and Dash 1, with i have installed the Eurosensor for Oil P and two Bosch temp sensors for oil and water.
RPM is wired straight to the coil.
I have a brand new CF card from RT and had the latest firmware sent to me today 905 (think thats right).
What is happening is that although i conifgure the dash 1 using the software when i put my CF card into the DL1 it says updating but does not change the screen settings. So at the moment i only have volts a and OP -17! All the screens 1-5 remain unchanged altought they should update to my new config.
All GPS functions seem to be working speed, long, lat etc.
I am missing something, could my DL1 be corrupt?
Thanks
Just Installed a Mk1 DL1 and Dash 1, with i have installed the Eurosensor for Oil P and two Bosch temp sensors for oil and water.
RPM is wired straight to the coil.
I have a brand new CF card from RT and had the latest firmware sent to me today 905 (think thats right).
What is happening is that although i conifgure the dash 1 using the software when i put my CF card into the DL1 it says updating but does not change the screen settings. So at the moment i only have volts a and OP -17! All the screens 1-5 remain unchanged altought they should update to my new config.
All GPS functions seem to be working speed, long, lat etc.
I am missing something, could my DL1 be corrupt?
Thanks