Temperature creeps up on its own
Posted: Sat Feb 28, 2009 11:46 pm
I have the DL1 linked to Dash2. Channel 1 is dedicated to Water Temp. It comes on at a reasonable level, but then gradually creeps higher (without the engine running). In about five minutes it's gone from 5 degrees to 30 degrees, and in half an hour maybe 150 degrees.
The sensor is a standard Caterham water temp sensor, with a 255 ohm pull up resistor to the 12V output of the DL1.
I can't quite figure out what would cause it to creep up in this manner. Other sensors (including oil temp) seem OK Any suggestions for what to check?
The sensor is a standard Caterham water temp sensor, with a 255 ohm pull up resistor to the 12V output of the DL1.
I can't quite figure out what would cause it to creep up in this manner. Other sensors (including oil temp) seem OK Any suggestions for what to check?