Page 1 of 1

analogue input

Posted: Fri Apr 07, 2006 8:00 pm
by bazza_c
I want to connect a switch that will allow me to manually mark 'lap-sector ' markers for later viewing in the x-y graph. Is it is just a case of connecting the 5v output to analogue input via a switch? Essentially I just want the analogue input to register a voltage increase, but it needs to be something that can be registered in a split second, and still viewed on the graph. I would need detailed guidance on how to wire ot correectly to the DL1 to avoid damaging it.

Posted: Sat Apr 08, 2006 5:52 pm
by jlucas
email support, I believe you can use the lap beacon input for this

Posted: Mon Apr 17, 2006 1:29 am
by RTUSA
Jeremy is right, just wire the beacon input to the 5V output through a momentary contact switch.