I have a car fitted with these wheel speed sensors;
http://www.kasensors.co.uk/KA-SP-wheel-speed-sensor.pdf
They were purchased for a different application and as such are NPN type sensors so therefore I believe not directly compatible with the DL2 logger that I have.
How would I go about connecting these sensors to the DL2?
Regards
Jake
Using NPN wheel speed sensors with DL2
Installation
Using the "schematic" on the top right of that PDF, you would replace the load with a 1K ohm 1/4 watt pull-up resistor and connect the black wire to a digital/frequency input on the DL2
Paul
Paul
Return to “Sensor-related questions”
Who is online
Users browsing this forum: No registered users and 26 guests