Honeywell MLH Pressure Sensors - resistor needed?

71dsp
Posts: 19
Joined: Sat Apr 19, 2008 4:07 pm

Honeywell MLH Pressure Sensors - resistor needed?

Postby 71dsp » Wed Apr 14, 2010 5:32 pm

I'm planning to use Honeywell MLH pressure sensors for F&R brake pressure and fuel pressure.

http://sensing.honeywell.com/index.cfm/ ... /1/re_id/0

The models I'm using require a +5V input and output 0.5V to 5V. Since the sensor output is voltage, I would assume I do not need a pull up/down resistor. Is this correct?
Billy
98 Prelude - #27 NASA TX PT

Support

Postby Support » Thu Apr 15, 2010 10:21 am

That is correct, you wont need a pull-up resistor in this case.


Return to “Sensor-related questions”

Who is online

Users browsing this forum: No registered users and 36 guests