pull up resistor formula
-
- Posts: 22
- Joined: Tue Jul 03, 2012 9:12 pm
Support
For fuel level you want strong filtering.
Smooth over the maximum... 100
Maximum rate of change is in units per sample. The DASH2 samples the analogue channels at 30 times per second (30Hz) If the data is coming in from a DL1 the default is 5 per second but can be configured upto 100 times per second.
Typically you want the fuel to change about 2 litres per second so it gets to the correct reading quickly when you switch it on to check.
so... 2/30= 0.6667
Kind regards,
K
Smooth over the maximum... 100
Maximum rate of change is in units per sample. The DASH2 samples the analogue channels at 30 times per second (30Hz) If the data is coming in from a DL1 the default is 5 per second but can be configured upto 100 times per second.
Typically you want the fuel to change about 2 litres per second so it gets to the correct reading quickly when you switch it on to check.
so... 2/30= 0.6667
Kind regards,
K
-
- Posts: 22
- Joined: Tue Jul 03, 2012 9:12 pm
Return to “Sensor-related questions”
Who is online
Users browsing this forum: No registered users and 12 guests