Dash2 on Clio 2 Mk1 2.0 16v with original harness and sensor
Posted: Tue Jul 22, 2014 1:17 pm
Hello.
I'm french so please excuse my English.
First of all, congratulations for the support that you bring to your customers. It is much appreciated!
If I posts here is that I need you. I wired my new dash2 on the origin of my Clio beam. I transplanted information on the original counter terminals.
The dash2 is on and basic functions are ok (flashing backlight ....) The wheel speed also.
For cons, I blocks on the rest despite a lot of testing and trial.
I blocks on the engine speed (RPM), no way to have a usable signal by dash2. Yet it is a single thread "engine input speed" on the original beam. Is there something more to the side of the motor flywheel sensor?
Side temperature sensor water so I blocks. The received signal is a resistor not a voltage.
How do I use this signal and with what kind of formula?
Then, also blocked the fuel level. The gauge goes from 0 to 300 ohms but how set in dash2?
Finally, I also have a problem with an oil temperature sensor VDO I can not use the same signal and also with the pressure sensor.
In short, not easy to install but I do not despair of solving these problems thanks to you!
Best regards
Seiz
I'm french so please excuse my English.
First of all, congratulations for the support that you bring to your customers. It is much appreciated!
If I posts here is that I need you. I wired my new dash2 on the origin of my Clio beam. I transplanted information on the original counter terminals.
The dash2 is on and basic functions are ok (flashing backlight ....) The wheel speed also.
For cons, I blocks on the rest despite a lot of testing and trial.
I blocks on the engine speed (RPM), no way to have a usable signal by dash2. Yet it is a single thread "engine input speed" on the original beam. Is there something more to the side of the motor flywheel sensor?
Side temperature sensor water so I blocks. The received signal is a resistor not a voltage.
How do I use this signal and with what kind of formula?
Then, also blocked the fuel level. The gauge goes from 0 to 300 ohms but how set in dash2?
Finally, I also have a problem with an oil temperature sensor VDO I can not use the same signal and also with the pressure sensor.
In short, not easy to install but I do not despair of solving these problems thanks to you!
Best regards
Seiz