Page 1 of 1

aem pressure sensor resistance

Posted: Wed Apr 29, 2015 7:20 pm
by capricol
I have an aem pressure sensor p/n 30-2131-150 that I am using for oil pressure on my dash2. although the sensor came with an instruction sheet it doesn't say the resistance in ohms , so I don't know what size pull up resistor to use. can anyone shed any light on this? It has the supply current, supply voltage ,operating temp, accuracy etc but no resistance value.

Posted: Wed Apr 29, 2015 8:07 pm
by peterguk
http://aemelectronics.com/files/instruc ... 20Data.pdf gives you voltage v pressure.

No resistor needed. Just connect to channel of your choice and use the RT software to setup the sensor from the graph.

Or send me an email to noblem500 (at) gmail.com and i'll reply with info.

Posted: Wed Apr 29, 2015 8:30 pm
by capricol
e mail sent

Posted: Wed Apr 29, 2015 9:54 pm
by peterguk
capricol wrote:e mail sent


Tried replying, mail bounced back "email address unknown".

See my edited post above.

Posted: Thu Apr 30, 2015 6:57 am
by capricol
ok. will try and sort it. thanks anyway.