Evenin all,
I'm fitting a Dash 2 into my Focus rally car and am hoping to use the std fuel level sender.
I don't suppose anyone else has done it and could pass on the settings, saving me a few hours?
Cheers all.
Pete
Mk1 Focus Fuel level sender
You will need to know what the ohm range is for the sender. Wire up the pull up network with the appropriate resistor. Then feed in 1 liter (or 1/2 gallon - or so) at a time and take some data.
If you know the sender's resistance range, you can approximate the amount with a linear extrapolation, but most OE gas tanks are not linear in how they fill. So you would likely be best to do it yourself.
If you know the sender's resistance range, you can approximate the amount with a linear extrapolation, but most OE gas tanks are not linear in how they fill. So you would likely be best to do it yourself.
BMW 2000 M Coupe
-
- Posts: 3
- Joined: Fri Sep 11, 2015 3:55 pm
-
- Posts: 3
- Joined: Fri Sep 11, 2015 3:55 pm
Re: Mk1 Focus Fuel level sender
Hi, did you find out the range of resistance for the mk1 focus?
Return to “Sensor-related questions”
Who is online
Users browsing this forum: No registered users and 13 guests