Hall effect wheel speed sensor..

trackxsi
Posts: 12
Joined: Sun Aug 10, 2008 7:36 pm

Hall effect wheel speed sensor..

Postby trackxsi » Sun Mar 08, 2020 1:09 pm

Apologies in advance if this has already been covered I did look but couldn't see anything..

Here goes!!..

I've been having trouble getting my speedo to register I had put it down to my trigger wheel teeth being too small so I changed that, still no joy...

I tested my sensor on the car (gave it power then tested the voltage over the signal and earth wires ) NOTHING!!

took it off the car and scratched my head a bit..

Then tested it directly to a 12v battery.. and it worked!!!

It appears the guy who made my look has only given the hall effect sensor 5v not 12!!

IF I get a new sensor that operates at the lover voltage, will the dash be able to pick up a 0-5v signal as opposed to a 0-12v one?????

Or am I going to have to tear the harness apart start again 😫😫😫😫😫

trackxsi
Posts: 12
Joined: Sun Aug 10, 2008 7:36 pm

Re: Hall effect wheel speed sensor..

Postby trackxsi » Sun Mar 08, 2020 1:34 pm

Actually... hang on... I can just run a wire from the 5v feed pin to the signal pin and make/break connection manually to see if it registers cant I?????

trackxsi
Posts: 12
Joined: Sun Aug 10, 2008 7:36 pm

Re: Hall effect wheel speed sensor..

Postby trackxsi » Mon Mar 09, 2020 8:45 pm

Turns out a 0-5v hall effect sensor can work the dash!!!

This was by just waving a steel bolt over the end of the magnet

Next job is to start sorting the other inputs out and the gear ratios...



https://youtu.be/mc9UsO4EiMY


Return to “Sensor-related questions”

Who is online

Users browsing this forum: No registered users and 3 guests