Page 1 of 1

EGT sensor failure

Posted: Wed Jul 15, 2020 8:52 pm
by Clarkey
Hi, I fitted an EGT sensor with my new dash 2 pro. First time out, the probe blew out of the threaded part of the sensor.
It had only done 10 minutes.
The threaded part screwed into the m6 fitting and i nipped the nut up, i was careful not over tighten, is this what i did wrong. does it need to done up tight!!
Looks like I got to buy another sensor and do not want the same thing happening .

Thanks

Re: EGT sensor failure

Posted: Mon Dec 21, 2020 8:31 pm
by peteg
i think there's a dodgy batch . i sent mine back as i could not see how it could possibly seal .