Page 3 of 3

Posted: Fri Apr 25, 2008 10:50 pm
by lsdweb1
And here's the chart showing the calculated values and those measured (using a footpump and spare gauge!)

Image

Posted: Sat Apr 26, 2008 9:45 am
by lsdweb1
I've posted all the VDO data I have - here

[/url]

VDO pressure sensor calibration files

Posted: Sun Aug 24, 2008 11:58 pm
by Mark
Hi
Can anyone please send VDO pressure sensor and Temp sensor calibration files they may have to suit Dash 2
mark@ballaratbolts.com.au
most appreciated
Cheers
Mark

Posted: Thu Dec 18, 2008 8:15 pm
by westysprinter
Support wrote:Hi Everyone,

I'm getting quite a few support questions relating to connecting the VDO sensors to our products... so I'm going to put up a wiki page o the site about them and how to set them up. If there is any calibration information available then please forward it to me at andrew at race-technology dot com and I'll make sure that it gets included!

Kind regards,

Andy


Come on Andy stick a link on then :D
I would like tables for 5 bar oil std water temp and fuel sender

Posted: Tue Jan 20, 2009 1:38 am
by 69VERT
VDO has a few technical support documents that include resistance charts for the instrumentation that they manufacture. You can find it here.

http://usa.vdo.com/products_solutions/c ... uments.htm