ok i thought i can follow instructions and have done so for installing the
Revs to my Dl1 from the coil on my pinto engine the DL1 is connected to my Dash 2 and dash 2 is configured for RS232 comms on REvs
the Problem 1000-2800 ish the desplay is fine nice and bold and increases nicly .
then 3000-upwards i get light flickering on the revs scale display on the Dash 2 and the shift lights flash madley all the lights and the display wont return to normal then
what am i doing wrong is it scaling ,Hz the delay the sample rate the avg or do i need king cable rings installing. to get better readings.
some one please Help im so disapointed in the product not being so simple, a software engineer couldnt fix the problem that im posting for Help
the rev limit is set to 6800 on a omex clubman rev limiter.
is this causing a problem as its also connected to the - on coil and + on coil and neg.earth if so do i need to remove the rev limiter or just use the king cable connection method. ive read the revs section in help file 4 times and printed out just to make sure i havent missed anything ive seen several posts about revs on Race technology products all seam to be car not product but the help file gives no clues
DAve
REvs
-
- Posts: 43
- Joined: Fri Mar 28, 2008 8:01 pm
- Location: westmidlands
- Contact:
-
- Posts: 43
- Joined: Fri Mar 28, 2008 8:01 pm
- Location: westmidlands
- Contact:
[img][img]http://img142.imageshack.us/img142/5328/rpmpicwy6.jpg[/img][/img]
for the run file give me an email adress and i can end you the file thanks
for the run file give me an email adress and i can end you the file thanks
-
- Posts: 43
- Joined: Fri Mar 28, 2008 8:01 pm
- Location: westmidlands
- Contact:
Return to “General software support”
Who is online
Users browsing this forum: No registered users and 15 guests