Page 1 of 1

PROBLEMS CONFIGURING DASH2 TO CAN MBE 9A4

Posted: Mon Mar 05, 2018 10:17 am
by KARL DET
I have started the installation of the dash2 with can adapter bought last month i have been having problems configuring the bought MBE can adapter to the 9a4ecu i have tried continuity to the can low and high that i have soldered that are ok have tried the continuity ti the terminator plug 12v and ground wire tried your racetechnology live software and no data received at all
The data stream is set in the ecu attached are the photos
Can you please help us with this situation as we are stuck thanks Karl
Sorry cannot send attachments as telling me file is too big have emailed to support

Re: PROBLEMS CONFIGURING DASH2 TO CAN MBE 9A4

Posted: Mon Mar 05, 2018 10:50 am
by racetec
Hi Karl

We have received your emails, thank you.
Somebody from our technical support team will be in touch to assist you as soon as they can.

Best regards,
Adele

Re: PROBLEMS CONFIGURING DASH2 TO CAN MBE 9A4

Posted: Mon Mar 05, 2018 10:51 am
by KARL DET
Thanks Adele