Hello, Im trying (& failing!) to get my Dash 2 and DL1 Sport to read from my Omex 600 ECU
Im using the interface cable. connected up as per diagrams. The ECU Telemetry is set as it should be
Dash 2 is all set-up to for Omex using latest configuration software
Both devises have been re=flashed and are on current firmware
i Know the DL1 & Dash are communicating as the analogue inputs I've set up all work fine
i read on one of the knowledge base articles that i need to set the DL1 to decode the serial outputs. That's where i get stuck, as there doesn't seem to be any option to do this on the DL1 Sport configuration software
Am i missing something? Any help appreachiated
Many thanks Mark
Dash 2 / DL1 Sport Omex ECU Interface
Re: Dash 2 / DL1 Sport Omex ECU Interface
On the DL1 SPORT the only configuration required is to tick the box to say that the RPM data should be taken from the ECU interface. If that is ticked then I suggest checking the RS232 data output from the DL1 using the Live Monitor so you can see exactly what is being transmitted.
Re: Dash 2 / DL1 Sport Omex ECU Interface
Thanks for the reply, didn't have long to check things last night. i tried what you suggested and still no joy. I will test with live monitor this evening.
One thing i did notice is that in the Omex map 4000 software there is a telemetry box for the map itself. As attached screen snip. Should either of these be 'on'?
One thing i did notice is that in the Omex map 4000 software there is a telemetry box for the map itself. As attached screen snip. Should either of these be 'on'?
- Attachments
-
- Capture.PNG (6.54 KiB) Viewed 13446 times
Re: Dash 2 / DL1 Sport Omex ECU Interface
I honestly don't know on that as I have never used that software. Given that there are two options I would try with one on, if it doesn't work try with the other.
Re: Dash 2 / DL1 Sport Omex ECU Interface
Thanks. A bit of lunch time reading & googling found me the following;-
https://www.race-technology.com/wiki/in ... X600And710
it looks like both need to be 'on' i will give it a whirl later and report back
https://www.race-technology.com/wiki/in ... X600And710
it looks like both need to be 'on' i will give it a whirl later and report back
Return to “General software support”
Who is online
Users browsing this forum: No registered users and 8 guests