Dash 2 / DL1 Sport Omex ECU Interface

mark-one
Posts: 5
Joined: Mon Jan 29, 2018 10:08 am

Dash 2 / DL1 Sport Omex ECU Interface

Postby mark-one » Sun Mar 18, 2018 8:39 pm

Hello, Im trying (& failing!) to get my Dash 2 and DL1 Sport to read from my Omex 600 ECU

Im using the interface cable. connected up as per diagrams. The ECU Telemetry is set as it should be

Dash 2 is all set-up to for Omex using latest configuration software

Both devises have been re=flashed and are on current firmware

i Know the DL1 & Dash are communicating as the analogue inputs I've set up all work fine

i read on one of the knowledge base articles that i need to set the DL1 to decode the serial outputs. That's where i get stuck, as there doesn't seem to be any option to do this on the DL1 Sport configuration software

Am i missing something? Any help appreachiated

Many thanks Mark

racetec
Site Admin
Posts: 326
Joined: Thu Oct 27, 2005 12:02 pm

Re: Dash 2 / DL1 Sport Omex ECU Interface

Postby racetec » Mon Mar 19, 2018 9:55 am

On the DL1 SPORT the only configuration required is to tick the box to say that the RPM data should be taken from the ECU interface. If that is ticked then I suggest checking the RS232 data output from the DL1 using the Live Monitor so you can see exactly what is being transmitted.

mark-one
Posts: 5
Joined: Mon Jan 29, 2018 10:08 am

Re: Dash 2 / DL1 Sport Omex ECU Interface

Postby mark-one » Tue Mar 20, 2018 8:13 am

Thanks for the reply, didn't have long to check things last night. i tried what you suggested and still no joy. I will test with live monitor this evening.
One thing i did notice is that in the Omex map 4000 software there is a telemetry box for the map itself. As attached screen snip. Should either of these be 'on'?
Attachments
Capture.PNG
Capture.PNG (6.54 KiB) Viewed 13100 times

racetec
Site Admin
Posts: 326
Joined: Thu Oct 27, 2005 12:02 pm

Re: Dash 2 / DL1 Sport Omex ECU Interface

Postby racetec » Tue Mar 20, 2018 9:29 am

I honestly don't know on that as I have never used that software. Given that there are two options I would try with one on, if it doesn't work try with the other.

mark-one
Posts: 5
Joined: Mon Jan 29, 2018 10:08 am

Re: Dash 2 / DL1 Sport Omex ECU Interface

Postby mark-one » Tue Mar 20, 2018 1:20 pm

Thanks. A bit of lunch time reading & googling found me the following;-

https://www.race-technology.com/wiki/in ... X600And710

it looks like both need to be 'on' i will give it a whirl later and report back


Return to “General software support”

Who is online

Users browsing this forum: No registered users and 6 guests