Turn off shift ligths on Dash3

datracer99
Posts: 6
Joined: Mon Jun 15, 2009 1:34 pm
Location: Sydney, Australia

Turn off shift ligths on Dash3

Postby datracer99 » Mon Jun 15, 2009 1:47 pm

I used to have a shift light which had 3 LEDs - which has now been replaced by a DL1 and Dash 3.

I had it set up so the first light came on below a set RPM - it was a useful quick indicator if i could use a lower gear - without needing to rev the hell out of the engine on the next lap to find out.

The Dash3 manual indiactes that it is possible to turn the lights on/off based on the configuration, but I can only see from the the instructions how it is possible to turn the lights on at a set RPM.
So, is it possible to turn a light on below a set RPM, and off above that RPM?

Also, is it possible to have different lights set based on different inputs. E.g have the lights all on for an alarm condition, but used for RPM based shift sequence when there is no alram condition?

Any advice appreciated - there is a lot to get around with the Dash3

Return to “General software support”

Who is online

Users browsing this forum: No registered users and 4 guests