Page 1 of 1

Link G4+ and Dash2

Posted: Fri Sep 22, 2017 4:33 pm
by sparkystav
Does anyone have a config file for a Link to Dash2 (not pro) via CAN please?

Would save me putting them all in.

Thanks!

Re: Link G4+ and Dash2

Posted: Fri Sep 22, 2017 9:34 pm
by sparkystav
Right I’ve got the two units talking.

But can I set the Dash2 (not pro!) to read custom CAN data? For example the lambda signal isn’t on the pre set Vipec/link drop down.

Re: Link G4+ and Dash2

Posted: Mon Sep 25, 2017 9:24 am
by Support (D)
Dear Sir / Madam,

In this installation you should have one of our 'CAN adaptors' installed between the dash and the ECU.

If you send me an email (daniel@race-technology.com), I'll send you the LINK G4+ file we have on our system for the CAN adaptor, this contains lambda 1 as a preset variable. Try this file and see how you get on.

Best regards,
Support(D)

Re: Link G4+ and Dash2

Posted: Sun Oct 22, 2017 9:49 pm
by sparkystav
Have just emailed thanks. Didn’t get a reply notification so sorry for the delay