Race Technology

Posted: **Fri Nov 29, 2019 3:53 pm**

Dash3 Manual:
<Load variable information>
<This allows you to load a new set of variable list from a VAR file to variable tree.>

How do I load a new variable list with the Dash3 configuration software?
The menu is missing the option as indicated in the help.
Where does the Dash3 configuration software get a list of variables?

: Dash3_Menue.jpg (37.45 KiB) Viewed 7571 times

The attachment Dash3_Menue.jpg is no longer available

Hustler

Posted: **Tue Dec 03, 2019 7:45 pm**

Spitballing here, but are you using v10 analysis software? I recently learned that v8.5 should be used with older devices since the v10 software pulls the variable list directly from the data file. I don't know if that also applies to the DASH-3.

Actually, I may have mis-stated this. From this link: viewtopic.php?f=8&t=4082

...on the older DL1 MK2 it was a "pain" as the sensor in volts->units conversion was done on the PC, so you had to keeping loading in different variable files...On later DL1s (MK3 onwards, sold from about 2008) the conversion from volts->units is done on the actual hardware, so the PC software doesn't typically need to "know" about the different configurations. This makes the situation much simpler.

Race Technology

Variable list not loadable

Variable list not loadable

Re: Variable list not loadable