I am using the Dash3 connected to a custom logger. I use the analog channels to send data to the dash. I have found that the values on the dash change depending on whether a decimal place is shown or not.
For example, I send the value 72 to the dash. If the dash is set to display the param with 1 or more decimal places the value correctly shows as 72.0, If I set the display to show 0 decimal places the value shows as 71.
This is unacceptable, why would the value on the dash be incorrect? There is a critical bug in the Dash3 software, you may not think it important but if you are trying to send a lap number (or any int number) you need that number to show correctly.
3 posts • Page 1 of 1
Yes you are correct, when you set to zero DP's the DASH3 truncates, not rounds as it should. We are working on a DASH3 firmware update and this will be included in the update.
Support - Andy
Using the latest firmware this issue is still not resolved. It's been a while, do you have any eta as this is a pretty major bug that most users do not realise they have.
Who is online
Users browsing this forum: No registered users and 1 guest