I bought a DL1 plus Dash2 plus MS2 ECU Interface. Now I want to get it to run with my MS3. The Stream length is different from MS2 however The Position of data within the Streams is remaining the same. Who can help me with an upgrade of my interface?
Please make it run. It would just be too cool.
Here the data section:
Code: Select all
[OutputChannels]
deadValue = { 0 } ; Convenient unchanging value.
#if CAN_COMMANDS
;full version that works anywhere - be sure to change the no. bytes requested
ochGetCommand = "r\x00\x07\x00\x00\x01\xaa"
#else
; fast get via serial
ochGetCommand = "A"
#endif
ochBlockSize = 426 ;oi! change ochGetCommand as well ; SIZEOFTXBUF
seconds = scalar, U16, 0, "s", 1.000, 0.0
secl = { seconds % 256 }, "s" ; For runtime screen.
#if PW_4X
pulseWidth1 = scalar, U16, 2, "ms", 0.004, 0.0
pulseWidth2 = scalar, U16, 4, "ms", 0.004, 0.0
#else
pulseWidth1 = scalar, U16, 2, "ms", 0.001, 0.0
pulseWidth2 = scalar, U16, 4, "ms", 0.001, 0.0
#endif
pulseWidth = { pulseWidth1 }, "ms" ; For runtime screen.
rpm = scalar, U16, 6, "RPM", 1.000, 0.0
advance = scalar, S16, 8, "deg", 0.100, 0.0
...................
--------
CUT