Megasquirt MS3 again, CAN can work now!!

thokes82
Posts: 38
Joined: Wed Oct 24, 2012 4:11 pm

Megasquirt MS3 again, CAN can work now!!

Postby thokes82 » Fri Apr 18, 2014 4:10 pm

Hi gents,
I would like to ask the support team to look into the following document and ask a programmer to give some feedback too. MS3 and MS2 are with their newest firmware finally able to send CAN commands according to a standard protocol.
http://www.msextra.com/doc/general/file ... -03-10.pdf

This is great news. Can somebody tell me if your CAN adapter can be configured to run with it? should be possible, actually. But what needs to be setup?

regards, Thomas

Support
Posts: 399
Joined: Mon Nov 21, 2005 4:09 pm

Postby Support » Tue Apr 22, 2014 8:17 am

I have been in discussion with James Murray about the development of this for some time and can confirm that the new format of data will be easily configurable on any of our CAN decoding units.

Martin
______________________________
Posted by Race Technology Support

thokes82
Posts: 38
Joined: Wed Oct 24, 2012 4:11 pm

Postby thokes82 » Mon Jun 09, 2014 7:11 am

My RT can Adapter sends not a single Byte on the lite monitor. I just do not know where to start searching. Would the adapter send anything even if there is no can connection?

thokes82
Posts: 38
Joined: Wed Oct 24, 2012 4:11 pm

CAN .dbc File For Megasquirt MS3 and MS2

Postby thokes82 » Thu Nov 20, 2014 1:51 pm

http://www.msextra.com/doc/pdf/Megasqui ... -10-27.dbc

Here above you find the .dbc file for MS2extra Firmware 3.4 and newer
and MS3 Firmware 1.4 and newer


Return to “General support questions”

Who is online

Users browsing this forum: Google [Bot] and 35 guests