I have a DTA80 > CAN Interface > DL1 (mk2) > Dash 3
I just can't get the analysis software to decode some of the ECU transmitted data, this includes the voltage and Lanbda from the DTA, in the analysis variables it shows data is available, but when graphed its just a '0' flat line. I know both the channels are being decoded as I can display them just fine on the Dash 3.
Many of the ECU channels like water, oil, pressure etc working just fine.
Any ideas?
Unable to display data on some channels from ECU in Analysis
-
- Posts: 36
- Joined: Sun Oct 31, 2010 9:36 am
Hi there,
Please send over the run file you are experiencing this in to sam@race-technology.com
I will take a look at this and see if I can replicate the issue.
Kind Regards,
RT Support (SK)
Please send over the run file you are experiencing this in to sam@race-technology.com
I will take a look at this and see if I can replicate the issue.
Kind Regards,
RT Support (SK)
______________________________
Posted by Race Technology Support
Posted by Race Technology Support
-
- Posts: 36
- Joined: Sun Oct 31, 2010 9:36 am
-
- Posts: 9
- Joined: Sat Apr 24, 2010 8:21 pm
- Location: Worcestershire
Hi Sam, I have the same issue as Rob. I have samples showing but they flatline. I am taking CAN data from DTA S100 for a range of variables successfully. However, I am not seeing 'good data' for crank errors, cam errors and analogue 3 gear pot voltage. I have tried resetting Analysis but even he default var definitions (Aux 2-4) show the flat line.
I have emailed my car and var files together with my dl1 config file and a short run data file. The gear pot is the best to look at since this definitely changes during the course of the run.
Look forward to your thoughts but please email if you need more. clivej.austin@gmail.com
Regards.
Clive Austin
I have emailed my car and var files together with my dl1 config file and a short run data file. The gear pot is the best to look at since this definitely changes during the course of the run.
Look forward to your thoughts but please email if you need more. clivej.austin@gmail.com
Regards.
Clive Austin
Clive Austin
Return to “General support questions”
Who is online
Users browsing this forum: No registered users and 58 guests