I am trying to setup my DL1 to record a wheel sensor on FREQ1 input. I have it on my bench with a 75Hz square wave input with 12V amplitude to Pin "T" of the 19 pin connector. I get no frequency data in the file. Also, the first three analog inputs do collect but only at 100Hx NOT at 1KHz as configured. Any ideas what might be wrong?
I have tried to attached my config file, DL1.CMG, but I get a error message saying my file has an incorrect extension??? Tried removing the extension but no luck???
Thanks,
Jeff (Newbie)
DL1 Pro not recording frequency
-
- Posts: 8
- Joined: Fri Nov 06, 2015 6:01 pm
- Location: Vancouver Canada
-
- Posts: 8
- Joined: Fri Nov 06, 2015 6:01 pm
- Location: Vancouver Canada
Solved: DL1 Pro not recording frequency
After reformatting the SD card twice and loading config file the DL1 logged the data correctly.
Thanks,
Jeff
Thanks,
Jeff
Return to “General software support”
Who is online
Users browsing this forum: No registered users and 7 guests