Hello,
I have a DL1club getting input from direct CAN, then going to my dash4pro.
I did get the correct number of RPM on the dash during the race: 850-950 rpm on tick-over.
But when I load the datafile from the logger into the analyses tool, I get 150-250 as RPM at the same moment.
Over my complete run, the scale only goes from 200 up to +/- 900 rpm.
Shouldn't it save the same info as it displays on the dash?
Thanks,
Koen
RPM divided by X on DL1club-logging but OK on DASH4PRO
-
- Posts: 7
- Joined: Thu Apr 21, 2016 6:57 am
Re: RPM divided by X on DL1club-logging but OK on DASH4PRO
Hello,
It is intented to store the RPM to the memory card as RPM*1. It is common that RPM is store at a half, quatar or double etc etc due to the number of pulses per 1 engine revolution varying. It is possible to adjust the settings in analysis but if stored incorrectly when overlaying 2 different cars with different pulses per revolution one will show up incorrectly.
It is possible to just change the RPM in analysis under Data> vehicle options> RPM. Divide the current by 4
Please watch video below showing how to change the RPM in DL1 CAN config, DASH and analysis.
https://youtu.be/F37D6HVLOmk
Kind regards,
Support (K)
It is intented to store the RPM to the memory card as RPM*1. It is common that RPM is store at a half, quatar or double etc etc due to the number of pulses per 1 engine revolution varying. It is possible to adjust the settings in analysis but if stored incorrectly when overlaying 2 different cars with different pulses per revolution one will show up incorrectly.
It is possible to just change the RPM in analysis under Data> vehicle options> RPM. Divide the current by 4
Please watch video below showing how to change the RPM in DL1 CAN config, DASH and analysis.
https://youtu.be/F37D6HVLOmk
Kind regards,
Support (K)
______________________________
Posted by Race Technology Support
Posted by Race Technology Support
-
- Posts: 7
- Joined: Thu Apr 21, 2016 6:57 am
Re: RPM divided by X on DL1club-logging but OK on DASH4PRO
perfect. thanks
Return to “General support questions”
Who is online
Users browsing this forum: Bing [Bot] and 182 guests