help needed im new to dash 2 and canbus
i have 15 channel licence
i believe the life is set correct as per rt instructions 120ohm resistor fitted
i have canbus emblem up on dash
but how do i configure to get data on the dash 2 pro
i have update firmware and selected 15 canbus channels from drop down messages .
what else do i need to do .
regards pete
dash 2 pro canbus set up to life ecu
Re: dash 2 pro canbus set up to life ecu
Hi Pete - We are already supporting this enquiry over email, I've replied today but please bear in mind Christmas is a very busy time for us.
Thanks
Thanks
______________________________
Posted by Race Technology Support
Posted by Race Technology Support
Re: dash 2 pro canbus set up to life ecu
yes received email and now working thankyou
Re: dash 2 pro canbus set up to life ecu
can the dash 2pro menu buttons be programmed via can bus please. and if so how .
Re: dash 2 pro canbus set up to life ecu
Only via USB connector and DASH2 PRO configuration utility, the Unit Control Inputs section is where you can change the settings.
Best regards
Best regards
______________________________
Posted by Race Technology Support
Posted by Race Technology Support
Re: dash 2 pro canbus set up to life ecu
was hoping to use wireless buttons on my steering wheel via canbus to change screens . and add markers, but im quessing you can only use the inputs .
Return to “General support questions”
Who is online
Users browsing this forum: No registered users and 13 guests