For some reason my lat/long accel values are always a fraction of what they should be... I've looked through all the settings and can't find anything that would cause this. My numbers are somewhere around 1/8 to 1/10 of what I would expect them to be. I've compared data with a friend from the same track at the same time and his numbers are fine. Any ideas?
Thanks
Lat/Long Accel values a fraction of what they should be....
Might be worth trying the folllowing simple test: (assuming you have the DL90/DL1)
Connect the logger to a PC and run the monitor software. Slowly tilt the logger vertically through 90 degrees (so its standing upright) the G values should rise to + or - 1G depending on the tilt axis. Try both axis and report on what values you get. You could always log this normally and analyse the data later post the charts.
HTH
Connect the logger to a PC and run the monitor software. Slowly tilt the logger vertically through 90 degrees (so its standing upright) the G values should rise to + or - 1G depending on the tilt axis. Try both axis and report on what values you get. You could always log this normally and analyse the data later post the charts.
HTH
I tried tilting it with the Dash1 attached (don't have my laptop here at work). The G values never rised above 0.12.
By, "correct units" is this a setting in the analysis software? Where is this setting? I can load in a firends run file into the same raf file with my runs and his runs have the correct G's and mine does not.
Thanks
By, "correct units" is this a setting in the analysis software? Where is this setting? I can load in a firends run file into the same raf file with my runs and his runs have the correct G's and mine does not.
Thanks
Return to “General support questions”
Who is online
Users browsing this forum: No registered users and 255 guests