I'm using a stock RT intake pressure sensor to record boost pressure as seen here:
http://www.race-technology.com/wiki/ind ... AndAmbient
In the software RT I'm using there is no intake pressure sensor in the dropdown of standard sensors and I can not work out how I am supposed to input:
Pressure [Bar] = (input - 0.5) / 4 * 2.3 + 0.2
I see the boxes I need to use when I select to use an equation, but I just don't see how this equation is entered. Can someone please explain what I put where? ta...
RT Intake Pressure Sensor equation
-
- Posts: 220
- Joined: Thu Mar 15, 2007 3:41 pm
- Location: Norwich, UK
- Contact:
Thanks tristancliffe but I'm afraid I'm still having problems In fact, I've got nowhere.
When I do as you suggest, it saves nothing.
When I put (input - 0.5) / 4 * 2.3 + 0.2 in and save it, it saves as y= +0.542.
You say add the number from the list on the right - the dash1 config screen has the following on the right:
Max rate of change
Number of samples
Channel name
Channel abreviation
Channel units
Decimal places
None of these entered in the lower box of the 'Enter equation manually' screen as input or varXXXX does anything either than not save or just gives me y = +0.542
Any other ideas?
When I do as you suggest, it saves nothing.
When I put (input - 0.5) / 4 * 2.3 + 0.2 in and save it, it saves as y= +0.542.
You say add the number from the list on the right - the dash1 config screen has the following on the right:
Max rate of change
Number of samples
Channel name
Channel abreviation
Channel units
Decimal places
None of these entered in the lower box of the 'Enter equation manually' screen as input or varXXXX does anything either than not save or just gives me y = +0.542
Any other ideas?
Return to “Sensor-related questions”
Who is online
Users browsing this forum: No registered users and 16 guests