I'm having some difficulty finding 1W resistors locally but can get hold of 0.6W and 2W ones easily enough.
Would any of those 2 be suitable?
If so, which ones. The 0.6W or the 2W?
Ta in advance
Quick resistor query
Choice
Not knowing the circuit it is going in, makes an intelligent decision impossible. So if 1W was what you wanted but can't find, then you should go to 2W and have some margin. Perhaps you can give us more information to help you make a better decision.
Paul
Paul
-
- Posts: 220
- Joined: Thu Mar 15, 2007 3:41 pm
- Location: Norwich, UK
- Contact:
Anyone got any idea as to which resistors I'll need.
I'm currently unable to get the bloody thing working/reading sensors without this little bit of much needed info.
Wanted
Stack ST81XX dash and logger sytem.
Will swap/PX for a relatively new/low mileage (160ish miles of use on a demo car) Dash2 and DL1 if I can't get it set up and working in the car.
I'm currently unable to get the bloody thing working/reading sensors without this little bit of much needed info.
Wanted
Stack ST81XX dash and logger sytem.
Will swap/PX for a relatively new/low mileage (160ish miles of use on a demo car) Dash2 and DL1 if I can't get it set up and working in the car.
Return to “Installation questions”
Who is online
Users browsing this forum: No registered users and 16 guests