Hi, I have consulted the forum and foun dtwo similar topics and followed advise but still cannot get the battery voltage to display. This is what I have done and tried a number of variations around this.
Take the voltage (12.63V) and feed into the analogue input on the DL1, Ive used Analogue 8 but this should not make any difference which one is used?
Apply a manual equation y=+1x and make this display on the Dash 2. This then give a number of minus 10612.
I've tried to make this correct with fancy equations but this doesn't work and I understand that the true reading on an anlgue input shold be the voltage.
What am I doing wrong please!?
Testing looms fast.......
Steve
Problem getting battery voltage to display on Dash 2
-
- Posts: 13
- Joined: Tue Dec 08, 2009 9:35 pm
- Location: nottingham
- Contact:
-
- Posts: 13
- Joined: Tue Dec 08, 2009 9:35 pm
- Location: nottingham
- Contact:
Thanks Osborni, I have all the other inputs (water, oil and throttle working OK into the DL1 and via the serial to the dash 2, and the dash.dot file works OK, ie I can minipulate equations and change screens etc on the CF card and make the Dash2 respond correctly. So I think I've done that OK.
I just don't se why the volts doesnt work the same? any thoughts?
I am going to try the dash 2 analogue input next as advised elsewhere.
Steve
I just don't se why the volts doesnt work the same? any thoughts?
I am going to try the dash 2 analogue input next as advised elsewhere.
Steve
-
- Posts: 13
- Joined: Tue Dec 08, 2009 9:35 pm
- Location: nottingham
- Contact:
Solved!
All I did was swap the battery voltage to input 6 as opposed to 8. Made a y=x equation and set up the dash screen.
Strangely I did this all on input 8 and it didnt work?
Anyway, all OK, just the rpm to get running now!
Return to “Installation questions”
Who is online
Users browsing this forum: No registered users and 18 guests