DASH2 data not captured on DL1 ?

mebilloz · Joined: 22 Mar 2011 Posts: 21 Location: Austalia

Hi
I have a DASH2, DL1, + ECU interface set up. The DL1 captures the data from the ECU fine, and the DASH2 displays the ECU data fine.
What doesnt seem to work, is the DL1 capturing the DASH2 anolouge inputs. I have these connected to capture fuel level, water temp etc but in 'Analysis' it indicates that there is no data avaible. If I export the data set to Excel, there is basically a 0 value for each of the 4 channels (A17, A18, A19, A20).

Any thoughts?

Ta

Bill

osborni · Joined: 07 Dec 2007 Posts: 473 Location: USA, Michigan

I don't have an ECU interface, but make sure that the serial links are all made. The Dash2-Tx might not be making it to the DL1-RX.

What order are your devices hooked up? With R-T supplied cables and per their diagram?
_________________
BMW 2000 M Coupe

mebilloz · Joined: 22 Mar 2011 Posts: 21 Location: Austalia

Hi

It is all RT stuff, and hooked up as per their diagrams. I will check the seating of the 2 9 pin plugs to make sure they are fully seated and hope that that is the problem.

Ta

Bill

mebilloz · Joined: 22 Mar 2011 Posts: 21 Location: Austalia

Tried reseating all the plugs with no luck. Still no data from the DASH2 to the DL1 Sad

ECU Serial data yes, DASH2 Analouge data -No.

Bill

osborni · Joined: 07 Dec 2007 Posts: 473 Location: USA, Michigan

Check the harness for continuity with a ohm meter?
_________________
BMW 2000 M Coupe