Hi,
I've got some brake pressure sensors from RT. Installed them and made the config in the dash2. I'm reading about -6 bar on both sensors.
Voltage 5v is comming from a dl1 and is also grounded at the DL1.
Is there an offset to these sensors? I used the standard bosch sensor settings.
Brake pressure sensors off-set
yes - then that makes sense.
We used to use a Bosch sensor which according to the spec was 0-250bar for 0.5v to 4.5v, only it wasn't correct as at rest all the sensors we saw read 6 to 7 bar, we tried to talk to Bosch about this error, but they never gave us a useful response.... so in the end we just changed the equation to account for this offset.
A while ago we changed suppliers for these and the new sensors comply correctly with the specification, with no pressure they give 0.5v... however we've not updated our "special Bosch corrected equation" and so at the moment you are seeing an offset.
The simplest work around it to enter an equation manually:
62.5 * x - 31.25
Note that because the brake pressure sensor is 250bar and 1% accurate, it not uncommon to see 1 or even 2 bar error at rest.
I'll ask that this updated equation is added as a standard option on all the softwares.
Kind regards,
Support
We used to use a Bosch sensor which according to the spec was 0-250bar for 0.5v to 4.5v, only it wasn't correct as at rest all the sensors we saw read 6 to 7 bar, we tried to talk to Bosch about this error, but they never gave us a useful response.... so in the end we just changed the equation to account for this offset.
A while ago we changed suppliers for these and the new sensors comply correctly with the specification, with no pressure they give 0.5v... however we've not updated our "special Bosch corrected equation" and so at the moment you are seeing an offset.
The simplest work around it to enter an equation manually:
62.5 * x - 31.25
Note that because the brake pressure sensor is 250bar and 1% accurate, it not uncommon to see 1 or even 2 bar error at rest.
I'll ask that this updated equation is added as a standard option on all the softwares.
Kind regards,
Support
Return to “Sensor-related questions”
Who is online
Users browsing this forum: No registered users and 189 guests