Measuring cylinder head tempreture on an air cooled engine

pete28
Posts: 6
Joined: Mon Apr 13, 2015 7:28 pm

Measuring cylinder head tempreture on an air cooled engine

Postby pete28 » Tue Oct 13, 2015 7:03 pm

Hi there
I'm just about to order a DL1 and Dash 2.
I have an air cooled engine that i would like to log the temperature of the cylinder heads. I currently use a very basic mechanical device from air cooled VW engined planes but I wondered if sometime like the exhaust gas temperature sender or something similar could be used. Ideally I would want to run the sensor under the plug so a ring terminal would be perfect.
Is there a ring type sensor that its compatible with the DL1?
Engine temp ranges from -10 to 250c
Any help appreciated
Regards
Pete

Bikey
Posts: 102
Joined: Fri Apr 29, 2011 6:05 am

Postby Bikey » Wed Oct 14, 2015 5:27 pm

If it is a thermocouple, which likely it is (and K type), you will need a 0-5 volt amplifier. These amplifiers are widely available and I think you can find the sensors very easily as they are used in karting (and elsewhere).


Return to “Sensor-related questions”

Who is online

Users browsing this forum: No registered users and 2 guests