issue setting up speedo Dash2

Posts: 1
Joined: Sun Feb 14, 2021 10:19 am

issue setting up speedo Dash2

Postby Whizz » Thu Feb 25, 2021 9:53 am

Morning All.

I am having a few problems getting a reading from my RTech wheel sensor. I have a red light on the sensor so getting power, will check later with multimeter to see if it is actually pulsing. Can anyone tell me what the optimum space is between sensor and target . I have 0.8mm at the moment. The target is exactly the same size as the sensor dia.

Return to “General software support”

Who is online

Users browsing this forum: No registered users and 1 guest